Filter
Top Products
6
2. Attach a Wheel (31) to the outside of the Base (1)
with an M10 x 78mm Bolt (81), three M10
W
ashers (75), and an M10 Nylon Locknut (76).
Do not overtighten the Locknut; the Wheel
m
ust be able to turn easily.
Attach the other Wheel (not shown) in the
same manner.
2
1
31
75
76
75
81
3. Orient the Cross Tube (11) as shown, with the
welded tubes at the bottom. Attach the Cross
Tube to the Upright (3) with two M10 x 147mm
Carriage Bolts (73), two M10 Washers (75), and
two M10 Nuts (47).
3
23
73
Welded
Tube
11
47
75
3
5. Lubricate an M10 x 103mm Bolt (66) with grease.
Attach the Bench Rail (5) to the Upright (3) with
the Bolt and an M10 Nylon Locknut (76). Do not
overtighten the Locknut; the Bench Rail must
be able to pivot easily.
T
ighten the Storage Knob (30) into the Upright (3)
and the Bench Rail (5).
4. Press the Front Leg Foot (27) onto the bottom of
the Front Leg (6). Note that the front of the
Front Leg Foot is taller than the back.
Attach the Bench Rail (5), with the hook on the
bottom, to the Front Leg (6) with four M10 x
25mm Button Screws (87).
4
5
5
Hook
27
Front
87
87
6
76
30
66
Grease
Insert the bolt
through this hole
5
3