Filter
Top Products
28.
Attach the Curl Pad (77) to the Curl Post (40) with
two 1/4" x 16mm Screws (82).
29.
Make sure that all parts have been properly tight-
ened.
The use of the remaining parts will be
explained in
ADJUST
MENTS, beginning on the
following page.
Before using the resistance system, pull the long
cable a few times to be sure that it moves
smoothly over the pulleys. If the cable does not
move smoothly
, find and correct the problem.
IMPORTANT: If the cables are not properly
installed, they may be damaged when heavy
resistance is used. See the CABLE DIAGRAM
on page 17 for proper cable routing.
12
27. Slide the Long Pad Tube (61) through the Front
Leg (6). Slide two Foam Pads (26) onto the tube.
Assemble the two Short Pad Tubes (9) to the
Leg Lever (7) in the same manner.
27
26
26
61
7
6
9
9
26. Locate the two Short Cables (33). Wrap one of
the Cables over a 90mm Pulley (28). Attach the
Pulley to a High Pulley Housing (21) with an M10
x 42mm Button Bolt (71) and an M10 Nylon
Locknut (76).
Repeat this step with the other Short Cable
(33).
26
76
71
21
28
33
25. Attach a 90mm Pulley (28) inside of the hole in
the Front Leg (6) with an M10 x 91mm Bolt (90),
two 26mm Spacers (52), two M10 Washers (75),
and an M10 Nylon Locknut (76). Make sure the
Pulley is above the Leg Lever Cable (32).
Slide the two free ends of the Leg Lever Cable
(32) onto the hook welded to the bottom of the
Bench Rail (5).
24
25
108
109
32
6
7
75
75
90
6
52
28
32
5
24. Locate the Leg Lever Cable (32), which has two
ends that are the same length and a third end
t
hat is longer.
R
oute the longest end of the Leg Lever Cable
(32) through the hole in the Front Leg (6), and
attach it inside of the hole in the Leg Lever (7)
with the Short Pin (109) and a cotter Pin (108).
76
52
28
77
40
82