Filter
Top Products
7
3. Attach the Crossbars (2, 3) to the Uprights (1)
with four M8 x 65mm Bolts (20), two Support
Plates (10), and four M8 Nylon Locknuts (24). Do
not tighten the Nylon Locknuts yet. Note the
position of the name decal and make sure the
Uprights are oriented as shown.
4. Press a 25.4mm Round Inner Cap (15) into the
indicated end of the Weight Tube (31). Slide the
Weight Tube through the hole in the Leg Lever (6).
Attach the Weight Tube with an M8 x 50mm Bolt
(29), two M8 Washers (26), a Sleeve (30), and an
M8 Nylon Locknut (24). Press a 25.4mm Angle
Cap (16) onto the other end of the weight tube.
Tap three 38mm Square Inner Caps (17) into the
Leg Lever (6) as shown.
Lubricate the M10 x 60mm Bolt (21). Attach the
Leg Lever (6) to the Front Leg (5) with the Bolt
and an M10 Nylon Locknut (27). Do not over-
tighten the Nylon Locknut; the Leg Lever must
be able to pivot freely.
4
27
17
17
17
6
5
15
31
16
21
24
26
26
30
29
3
10
10
20
20
20
24
24
24
3
2
1
1
Name
Decal
5. Press four 25.4mm Square Inner Caps (19) into
the Backrest Tubes (7).
Attach the Backrest Tubes (7) to the Backrest (8)
in the indicated locations, with three M6 x 38mm
Screws (23) and three M6 Washers (25). Do not
tighten the Screws yet.
8
25
25
25
23
23
7
7
23
19
19
19
5