Filter
Top Products
5
1. Before beginning assembly, be sure that you
have read and understand the information in
the box above.
Set the Base (9) on the floor. The indented holes
in the Base must be facing the floor.
Press two 38mm x 50mm Inner Caps (16) into the
Base (9). Insert four M8 x 48mm Carriage Bolts
(3) up through the Base.
2. Slide the Left Upright (1) onto the indicated M8 x
48mm Carriage Bolts (3). Hand-tighten an M8
Nylon Locknut (7) onto each Carriage Bolt. Be
sure that the Upright is turned as shown. Do not
tighten the Nylon Locknuts yet.
Attach the Right Upright (22) in the same manner.
Attach the Left Barbell Lock Pin (30) to the Left
Upright (1) with an M8 Nylon Locknut (7). Attach
the Right Barbell Lock Pin (17) to the Right
Upright (22) in the same manner. The Barbell
Lock Pins must be oriented as shown.
1
ASSEMBLY
Before beginning assembly, carefully read the
following information and instructions:
• Place all parts of the WEIDER
®
PRO 205 in a
cleared area and remove the packing materials;
do not dispose of the packing materials until
assembly is completed.
• Read each assembly step before you begin.
• For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART on the previous page. Note: Some
small parts may have been pre-attached for ship-
ping purposes. If a part is not in the parts bag,
check to see if it has been pre-attached.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the WEIDER
®
PRO 205, make
sure that all parts are oriented as shown in the
drawings.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
• Two (2) adjustable wrenches
• One (1) standard screwdriver
• One (1) rubber mallet
• Lubricant, such as grease or petroleum jelly,
and soapy water will also be needed.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
The Indented
Holes must
face the floor
2
9
16
16
3
3
1
22
3
7
30
17
7
7