Filter
Top Products
13
22. Remove the upper 3/8Ó x 3Ó Bolt (45) from the Top
Frame (1) and the Main Upright (3).
Feed the bolt on the High Cable (73) down through
the indicated slot in the Main Upright (3) in the direc-
tion shown.
Wrap the High Cable (73) around a 4Ó Pulley (35) in
the direction shown. Attach the Pulley inside the slot
in the Main Upright (3) with a 3/8Ó x 2 1/2Ó Bolt (54),
two 3/8Ó Flat Washers (55), two 5/8Ó x 1/2Ó Pulley
Bushings (42), and a 3/8Ó Nylon Jam Nut (63).
Re-insert the 3/8Ó x 3Ó Bolt (45) and secure it with a
3/8Ó Nylon Locknut (50). Note: The Cable (73) must
be seated in the groove of the Pulley (35) before
the Bolt is attached.
22
Bolt
Slot
35
73
55
54
42
55
3
42
63
45
50
1
24. Wrap the High Cable (73) down around a 4Ó Pulley
(35) in the direction shown. Feed the bolt on the High
Cable (73) back through the slot in the Main Upright
(3) as shown. Attach the Pulley to the Press Frame
(12) with a 3/8Ó x 8 1/2Ó Bolt (59) and a 3/8Ó Nylon
Locknut (50).
23
24
Bolt
Slot
35
73
Welded Tube
55
55
50
59
73
42
55
59
50
3
12
35
12
Slot
Bolt
42
54
35
23. Feed the bolt on the High Cable (73) under the weld-
ed tube on the Press Frame (12) as shown. Wrap the
High Cable down around a 4Ó Pulley (35) in the direc-
tion shown. Attach the Pulley to the Press Frame (12)
with a 3/8Ó x 8 1/2Ó Bolt (59) and a 3/8Ó Nylon Locknut
(50).
Wrap the High Cable (73) down around another 4Ó
Pulley (35). Attach the Pulley inside the indicated slot
in the Main Upright (3) with a 3/8Ó x 2 1/2Ó Bolt (54),
two 3/8Ó Flat Washers (55), two 5/8Ó x 1/2Ó Pulley
Bushings (42), and a 3/8Ó Nylon Jam Nut (63).
63