Filter
Top Products
20. Remove the pre-assembled 4Ó Pulley (not shown)
from the Pulley Bracket (91).
Attach the end of the Leg Press Cable (76) to the
Pulley Bracket (91) with a 1/4Ó Flat Washer (71) and
a 1/4Ó Nylon Locknut (25).
Lay the Pulley Bracket (91) and the Leg Press
Cable (76) aside; they will be attached in step 28.
20
71
25
91
76
19. Wrap the Leg Press Cable (76) around a 4Ó Pulley
(35). Attach the Pulley and a Cable Trap (44) to the
welded bracket on the Stabilizer (5) with a 3/8Ó x 2Ó
Bolt (62) and a 3/8Ó Nylon Locknut (50).
19
50
62
12
21. Identify the High Cable (73), which has a ball on
one end and a bolt on the other end.
Feed the end of the High Cable (73) with the bolt up
through the indicated slot in the Main Upright (3).
Feed almost all of the Cable through the slot.
Slide a 3/8Ó Flat Washer (55) and a 5/8Ó x 1/2Ó Pulley
Bushing (42) onto a 3/8Ó x 2 1/2Ó Bolt (54).
Wrap the High Cable (73) around a 4Ó Pulley (35).
Hold the Pulley inside the indicated slot in the Main
Upright (3). Insert the 3/8Ó x 2 1/2Ó Bolt (54) through
the Main Upright and the Pulley.
Slide another 5/8Ó x 1/2Ó Pulley Bushing (42) and 3/8Ó
Flat Washer (55) onto the 3/8Ó x 2 1/2Ó Bolt (54).
Tighten a 3/8Ó Nylon Jam Nut (63) onto the Bolt.
Remove the pre-assembled 4Ó Pulleys (35) from the
Press Frame (12), and set them aside.
21
Ball
Bolt
Slot
35
12
73
55
54
59
42
55
3
42
63
35
50
35
76
5
44
Bracket