Filter
Top Products
9
11
10
50
58
7
47
58
21
7
21
6
50
6
42
10. Wrap the Long Cable (58) around a “V”-Pulley
(6). Attach the “V”-Pulley and a Long Cable Trap
(50) to the indicated bracket on the Front Upright
(42) with a 3/8” x 2 1/2” Bolt (7) and a 3/8” Nylon
Locknut (21). Be sure that the Long Cable Trap
is positioned to hold the Cable in place.
11. Route the Long Cable (58) around a “V”-Pulley
(6). Attach the “V”-Pulley and a Long Cable Trap
(50) to the Left Arm (47) with a 3/8” x 2 1/2” Bolt
(7) and a 3/8” Nylon Locknut (21). Be sure that
the Cable is in the groove of the Pulley and
that the Long Cable Trap is positioned to hold
the Cable in place.
12
48
21
50
7
6
58
12. Route the Long Cable (58) around a “V”-Pulley
(6). Attach the “V”-Pulley and the Long Cable
Trap (50) to the Right Arm (48) with a 3/8” x 2
1/2” Bolt (7) and a 3/8” Nylon Locknut (21). Be
sure that the Cable is in the groove of the “V”-
Pulley and that a Long Cable Trap is turned to
hold the Cable in place.
13. Refer to the inset drawing. Using a 5/16” x
5” Bolt (64) and a 5/16” Nylon Locknut (3), attach
the Pulley Bracket (20) to the indicated bracket
on the Top Frame (55). Note: The Pulley
Bracket is pre-assembled with a 3 1/2” Pulley
(15) and a Cable Trap (66).
Route the Long Cable (58) around the 3 1/2”
Pulley (15) attached to the Pulley Bracket (20).
Be sure that the Cable is in the groove of the
Pulley and that the Cable Trap (66) is turned
to hold the Cable in place. Make sure that the
3/8” x 2” Bolt (12), securing the Pulley and Cable
Trap to the Pulley Bracket, is properly tightened
and that the Pulley Bracket can pivot freely.
13
58
66
15
12
20
64
55
20
66
3