Filter
Top Products
7
4
4
Tube
Welded
Spacers
17
59
Lubricate
21
3. Press a 1 3/4” Square Inner Cap (44) into each
end of the crossbar on the Top Frame (55). Press
two 1” Inner Caps (61) into the top of the crossbar.
Press a 2” Square Inner Cap (27) into the top of
the Rear Upright (56).
Attach the Top Frame (55) to the Front Upright
(42) with two 5/16” x 2 3/4” Bolts (11), two 5/16”
Washers (8), and two 5/16” Nylon Locknuts (3).
Attach the Top Frame to the Rear Upright (56)
with two 5/16” x 2 1/2” Bolts (22), two 5/16”
Washers, and two 5/16” Nylon Jamnuts (72).
Tighten the Nylon Locknuts used in steps 1–3.
4. Press a 1” x 7/8” Plastic Bushing (26) onto each
welded spacer on the Press Frame (17). Slide the
Press Frame onto the Base (4) so the Plastic
Bushings are aligned with the indicated tube.
Note: This will be a tight fit. The Plastic
Bushings should fit onto the ends of the tube
in the Base.
Lubricate a 3/8” x 8” Bolt (59). Attach the Press
Frame (17) to the Base (4) with the Bolt and a
3/8” Nylon Locknut (21).
ARM ASSEMBLY
3
22
11
8
8
44
44
61
27
55
56
42
3
Crossbar
72
8
26
5. Press a 1 3/4” Square Inner Cap (44) into the top
of one of the Press Arms (46). Press a 1” Round
Inner Cap (49) into each end of the handle on the
Press Arm. Attach the Press Arm to one side of
the Press Frame (17) with two 5/16” x 2 1/2” Bolts
(22) and two 5/16” Nylon Locknuts (3).
Assemble the other Press Arm (46) in the same
manner.
6. Identify the Right Arm (48) and the Left Arm (47).
Note the position of the welded bracket on each
Arm. Arm identification is very important for
step 7.
46
3
22
46
49
49
44
17
44
49
5
48
47
Welded
Brackets
6