Filter
Top Products
12
3
STEP
• While holding upright, place the bracket
end of the swing arm support (AC2) over
the holes in center floor support (AG3).
The swing arm support should be facing
the front of the machine. Secure the support
using two bolts (M10x75), four flat washers
(10.2x22x2), two nylon nuts (M10).
Vertically attach a bolt (M10x25), a lock
washer (10.2x18.4x2.5), and a flat
washer (10.2x22x2). Wait to tighten all
attachments until after this step is completed,
as it will allow for easier assembly.
• With the dual pulley bracket (AF1)
facing the front align holes in bottom of
bracket with remaining holes on the center
floor support. Fasten together using two
bolts (M10x75), four flat washers
(10.2x22x2), two nylon nuts (M10).
• Secure the connecting support frame
(AG1) between the swing arm support
and the seat support. Use four bolts
(M10x70), eight flat washers (10.2x22x2),
and four nylon nuts (M10) to attach the
connection.
PINK BAG