Vision Fitness ST750 Home Gym User Manual


 
10
1
STEP
NOTE: During assembly, it is recommended
to ensure that all bolts are in place and
partially threaded before completely tightening
any one bolt. During assembly steps 1 thru
4, do not completely tighten any bolts until
completion of Step 4.
• Lay the rear floor support (AG2) flat on
the ground, with pulley brackets on the
top. Stand up seat support frame (AC1)
and align holes along bottom of seat
frame with end of rear floor support.
Attach using two bolts (M10x70), four flat
washers (10.2x22x2), and two nylon nuts
(M10).
• Place the T-shaped end of the center
floor support (AG3) up against the holes in
the middle of the rear floor support. Make
sure L-shaped end is facing away from
seat support frame. Secure connection
using two bolts (M10x70), four flat washers
(10.2x22x2), two nylon nuts (M10).
ORANGE BAG