61
7.2. FLUORESCENT TUBE INSTALLATION
1. Make sure that the Lantern Switch is Off.
2. Press the new fluorescent tube’s base into the Tube Socket Assembly.
3. Replace the Tube Socket Assembly so that the two Support Rods pass
through the assembly and it is fully seated against the clear plastic dome.
4. Replace the two nuts and tighten (clockwise) so that the tube assembly is snug.
5. Screw on (clockwise) the End Cap until it is snug.
6. Test the fluorescent tube for proper operation by reconnecting the battery
and turning On the Lantern switch.
8. FUSE REPLACEMENT
The fuse is located inside the DC plug. (See Figure 5 for fuse replacement.)
Make sure the DC Recharge connector is disconnected from the Sport Spot Lantern.
FUSE REPLACEMENT PROCEDURE
1. Unscrew (counterclockwise) the flange from the DC plug.
2. Remove the flange, contact and fuse from the plug assembly.
3. Replace fuse with a .5 amp fuse of same type and size.
4. Place the center contact in the flange.
5. Replace the center contact and flange on the DC plug.
6. Tighten (clockwise) until the flange is fully seated.
DO NOT OVERTIGHTEN FLANGE!
9. BA
TTERY REPLACEMENT
The battery is contained in a compartment in the base of the unit. A plate must be
removed to gain access to the battery. Figures 5A and 5B show access to the
battery compartment.
FLANGE CONTACT
FUSE
SPRING PLUG
SWITCH
AC/DC
RECHARGE
BARREL
RECEPTACLE
SPADE CONNECTOR
SPADE
CONNECTOR
BATTERY
SPADE
LUG
TERMINALS
BATTERY
COMPARTMENT
COVER
TAB
1. INTRODUCTION
Congratulations on purchasing the Vector Sport Spot Lantern, an advanced design
combination spotlight and lantern. It instantly converts use from a powerful spotlight
to a soft, long-lasting area light. See Figure 1A and 1B. It uses a powerful
proven-technology, rechargeable, sealed lead acid battery that allows for years of
dependable use, recharge after recharge. It was designed from the ground up to
be the most versatile and practical light for travel, camping, picnicking, tailgate
parties and boating. The Sport Spot Lantern gives you the kind of light you need,
when and where you need it.
FIGURE 1A FIGURE 1B
Two recharge adapters are supplied with the Sport Spot Lantern. It is rechargeable
from either a DC cigarette lighter type 12 volt DC socket (accessory socket) or from
any 120 volt 60 Hz AC receptacle. 12 volt DC power is available from most
vehicles, boats, jump starters and portable battery packs. Vector has a variety of
portable power products that may be considered as companions to your Sport Spot
Lantern. Contact Vector for additional information.
SPOTLIGHT ON/OFF
LANTERN SWITCH
RECHARGE LEDS
°
FIGURE 5
FIGURE 5A FIGURE 5B
VEC128SL_ManualEN_092605 9/26/05 9:20 AM Page 7