Filter
Top Products
GB
18
8 . Battery change
Tip: Take down your total distance and wheelsize prior to battery change.
8.1 Changing the battery in the computer head
see chapter 1.4. Watch out: old batteries require special disposal
9. Troubleshooting
This chart outlines possible malfunctions, their causes and solutions.
malfunction possible cause solutions
speed display check for proper distance between readjusting distance between sensor
does not appear sensor and magnet and magnet
sender battery empty check battery power and
replace if necessary.
computerhead is incorrectly twisted on place computerhead on handlebar
handlebar holder holder and twist until detent (CLICK)
no wheelsize entered enter your wheelsize
sender is too distant from computerhead mount sender closer to computerhead
display fades battery in computer empty check battery power and replace it if
or disappears necessary
temperatures below 5° C (40° F) dull back in normal temperatures, display
display readout picks up working correctly
10. Warranty
We warrant VDO CYTEC models (sensor, computer head and handlebar holder) to the original purchaser
for five years from date of purchase against defects in material and workmanship. This does not cover
the batteries and defects resulting from normal wear and tear, improper care, accidents,
abuse or alteration.
Please take care to retain your receipt of purchase.
In case of legitimate complaints, you are entitled to receive a comparable replacement model. Due to
possible model changes, your model might not be available any more.
You may contact your retailer or store where you purchased your
VDO CYTEC or send the computer directly to us:
CYCLE PARTS GMBH
Grosse Ahlmuehle 33
76865 Rohrbach / Germany
In case of technical queries, call our consumer-service-hotline Tel. +49-6349-9635-10
Technical specifications of VDO CYTEC C05+ are subject to change.