Filter
Top Products
8 ::
:: 9
DISPLAYS
A signal light indicates which parameter is being used.
:: Speed = running deck speed (0,5-16 km/h / 0,3-10 mph).
:: kcal = energy consumption (0-9999 kcal).
:: Time = exercise duration (at 1 second intervals 00:00-59:59 up to
1 hour, and at 1 minute intervals thereafter 1:00-99:59).
:: Elev = elevation angle (0-10 %). 1 % corresponds to a 1 metre rise
per 100 metres.
:: Dist = training distance (0.1-999.9 km).
:: Pulse = heart-rate measurement (0-220). A heart-rate belt is
required to measure the heart-rate. The user interface displays —
if the heart-rate measurement feature is not in operation.
ERROR CODES
The user interface will display information about any operational faults.
An error code begins with the abbreviation Err.
13 Running deck speed exceeds set value: Please follow this manual’s
instructions on using the device.
15 Running deck does not respond to controls: Please check running
deck lubrication and follow this manual’s instructions on using
the device.
71 Lift motor fault or lifting motor overload protection off: Please
switch the device off for 5 minutes and then restart. If the error
message does not disappear, please contact your local Tunturi
distributor.
Remove the error code by pressing the RESET key. If any of these error
codes appears repeatedly despite servicing, or if a code other than the
above is displayed constantly, please contact your Tunturi dealer.
CUSTOM START
In Manual mode, use Custom Start to begin an exercise where speed and
elevation are preset by the user. You can save the Custom Start values by
setting the desired speed and elevation, and then pressing the Custom
Start key for 2 seconds: an audio signal indicates that the setting is saved.
For user safety, the speed range on the key is 0,5-10 km/h (0,3-6,2 mph).
SETTING KEYS, OK AND SCAN
Setting keys are used to set the values on-screen. The left/right keys are
used for navigation, while the up/down keys are used to set values.
The OK key in the middle of the setting keys is used to confi rm your
selections.
Pressing SCAN key changes the displayed values.
SPEED CONTROL KEYS
Speed control keys (Tortoise/Hare) are located below the display. Hare
key increases the belt speed in 0,1 km/h (or 0,1 mph) increments, the
tortoise key decreases it in 0,1 km/h (or 0,1 mph) increments. Pressing
these keys longer makes the speed change faster. Track speed ranges from
0,5-16 km/h (0,3-10 mph).
ELEVATION CONTROL KEYS
Elevation control keys (elevation arrows up and down) are located
below the display. The elevation up key increases the elevation in 1 %
increments, the elevation key down decreases it in 1 % increments. Track
elevation ranges from 0 % (horizontal) to 10 %.
STOP
Press STOP to end your exercise.
Press STOP once in exercise profi le training and the treadmill stops and
moves into its waiting state for 5 minutes. You can restart the interrupted
exercise by pressing the Hare key within 5 minutes. Press STOP twice
to end your exercise.