Filter
Top Products
10 ::
:: 11
5.7 SET
1. To set the heart-rate limit press SET once. The lower heart rate
limit is indicated by the text LO and the upper limit by HI. If
desired, the user interface indicates when your heart rate falls
below the lower limit or exceeds the upper limit with an alarm. To
set heart rate limits procede as follows:
:: The lower limit (LO) may be set between 50 and 220 beats per
minute. Use the - or + keys to set the value and press OK to
confi rm. Set the upper heart-rate limit (max. 220) in the same way
as for the lower limit. Press OK to confi rm.
:: To delete heart-rate limits use the - or + key to move the values
above the permitted upper or lower limit. The value is then
replaced by — on the display.
2. To select the alarm press SET twice. The text Ind OFF indicates
that the alarms are switched off and Ind ON that they are
switched on. Use the - or + keys to select OFF or ON and press
OK to confi rm.
3. To set units of measurement press SET three times.
:: Default units are rpm, km and kcal.
:: To change the units press the + or - key until the desired units are
displayed.
:: To measure speed you can set either revolutions per minute,
(rpm), kilometres per hour (km/h) or miles per hour (mph).
Energy consumption measurement can be set for kilocalories
(kcal) or kilojoules (kJ).
:: In addition to rpm you can also select either kilometres (km) or
miles as distance measures. If km/h is selected as the unit to
measure speed, km will automatically be the unit for distance. The
same applies to the units mph and miles.
:: Press OK to confi rm your selections, which are then saved and
indicated on the main display.
:: Press the RESET key to exit the setting function without saving
the adjustment. This resets the readings on the main display.
6. MAINTENANCE ::
:: In training, T.I.E. interface tolerates an environment measuring
+10°C to +35°C. A T.I.E. interface can be stored in temperatures
ranging between -15°C and +40°C. Air humidity in the T.I.E.
interface training or storage environment must never exceed 90 %.
:: Press the keys with the tip of the fi nger; your nails may damage
the key membrane.
:: Do not let the T.I.E. interface come into contact with water.
Always dry the surface of the interface, if there are any drops of
sweat on it. Use a soft, absorbent cloth. Do not use solvents to
clean the user interface surface.
:: Protect the user interface from excess sunlight: it may fade the
colours of the user interface box and surface membrane.
:: Please contact your dealer immediately if you notice any defects or
malfunctions while using your T.I.E. interface. Please state the
nature of the problem, conditions of use, purchase date and serial
number of your T.I.E. interface. The location of the serial number
sticker is shown on the inside cover.
:: At the end of this manual, you’ll fi nd a diagram and list of spare
parts for the Alpha 150.
:: T.I.E. user interfaces meet the requirements of the EU’s EMC
Directives on electromagnetic compatibility (89/336/EEC) and
electrical equipment designed for use within certain voltage limits
(73/23/EEC). This product therefore carries the CE label.
NOTE! The instructions must be followed carefully in the assembly,
use and maintenance of your equipment. The warranty does not cover
damage due to negligence of the assembly, adjustment and maintenance
instructions described herein. Changes or modifi cations not expressly
approved by Tunturi Oy Ltd will void the user's authority to operate
the equipment!
Due to our continuous policy of product development, Tunturi reserves
the right to change specifi cations without notice.
We wish you many enjoyable training sessions with your new
Tunturi training partner!