Filter
Top Products
Z 8 a n d Z 9 S e r i e s Tr e a d m i l l O w n e r ' s G u i d e
66
Care and MaintenanCe
Or to indicate an error in speed or incline:
INVALID INCLINE DATA (bAd grad dAtA)
INVALID SPEED DATA (bAd SPd dAtA)
CALIBRATION ABORTED: (CAL StOP)
NO SPEED SENSOR (nO SPd SEnS)
4. Remove and replace Safety Key and exit Calibration Mode
e following Error Codes and Service Codes will follow a double “beep”
and show on the display. Service Codes provide preventative maintenance
reminders. A Service Code will repeat for the next five times you start the
treadmill. A Service Code will clear after any key has been pressed. When
an Error Code occurs, call an authorized service technician.
Z.//./. Z D
E1: MINIMUM
E1 Not used
E1:RANGE E1 r
is error occurs when the incline values on the
display do not match the values stored during
calibration.
E1:STALL E1 S
is error occurs when the incline motor does
not move in response to an incline command.
E1:INCLINE E1 i
is error occurs when the incline motor moved
without an incline command.
E2:OVERSPEED E2 O
is error occurs when acceleration exceeded
design limits.
E2:CAL E2 C
is error occurs when the speed displayed does
not match the stored value from calibration.
E2:RECAL E2 r
is error occurs when a data error is detected
at start up. e Control Panel has reset to de-
fault values.
E5:SENSOR E5 S
is error occurs when no speed sensor data has
been detected at the Control Panel.
Error Codes
Care and maIntenanCe
error and
S
erviCe CodeS