Filter
Top Products
Assembly
Hardware Kit:
1. Safety key
2. 5mm T-handle hex key
3. 5mm hex key/Philips screwdriver
4. 3mm hex key
5. 2mm hex key
6. 8mm x 15mm hex screws (4)
7. 8mm x 50mm hex screws (2)
8. 6mm x 15mm hex screws (4)
9. handrail clamps (2)
Step 1: Carefully unpack treadmill and check that all
hardware is present as shown.
Step 2: Remove motor cover by taking out the six screws
with Philips screwdriver.
Step 3: The upper wiring harness is tucked into the bottom
of the right pedestal leg. Lay the pedestal on the treadmill as
shown on page 6.
Assembly
5