Filter
Top Products
24
When you start your watch for the rst time, the time shown
is 12:00 A.M. When the watch receives a signal, it auto-
matically places itself on the correct local time (generally in
a few minutes).
The reception covers most metropolitan areas in
the United States and Canada. If your watch is located in
one of these areas, it will receive the correct local time auto-
matically (unless the watch‘s „Radio“ setting is on „OFF“). If
your watch is located outside a broadcasting area, the time
will have to be set by hand. For any further information con-
cerning coverage areas, go to www.msndirect.com and
click on the Help link.
It may occur that the topography (hills, valleys), the structure
of the building in which you are located, or other electronic
devices, disturb the broadcasting signal that your watch uses
to receive information. When this occurs, a few minutes are
needed for your watch to receive the correct time.
Make sure that the „Time zone“ menu of the „Settings“
mode displays „Autoset“ for „Zone 1“.
If your watch is ahead of time by 5, 10 or 15 minutes, it is li-
kely that a „Time offset“ has been congured (see page
21).
If you are outside a coverage area, you can set the time on
your watch by hand (see page 21).
Don‘t worry! Simply connect your watch to the charger. All
the information will be accessible again as soon as the watch
has regained an adequate charge level and has restarted.
Start your watch again by pressing simultaneously the three
push buttons PREVIOUS, ENTER and NEXT. After a few
seconds, the SWATCH
®
welcome page appears and is then
replaced by a watch faceshowing the time. If your watch still
does not respond, contact the SWATCH
®
customer service
organization.
It is possible that you did not receive the activation and con-
guration message that was sent to you when you activated
the service. This can occur if you are outside the
t broadcasting area or if you are temporarily in an area in
which reception is poor. You can ask the ser-
vice to send back a conguration message by logging on to
www.msndirect.com. Click on „Sign In“, identify yourself
with the help of your Net passport and then go to the „Chan-
nels“ page. Click on the „Watch not receiving content?“
link in order to retrieve the information.
My watch does not display the correct time.
What should I do?
FAQ‘s
My watch‘s storage battery is spent before
I start recharging it. What should I do?
My watch responds to no push button. What
should I do?
I have activated the service but
my watch receives none of the information
that I have selected. What should I do?