Filter
Top Products
Page 4 of 9Star Trac Product Support 800-503-1221
Page 4 of 9
Installation of the Saddle and Seat Slider
1. Install the seat post into the frame and lower it to the lowest position and tighten the pop pin securely.
2. Slide the seat slide into the top of the seat post with the saddle pointed towards the front of the bike.
NXT Only
1. Rotate the seat slider lock knob as needed so that the slider clamp is in
alignment with the guide rail
2. There is a locking pin under the saddle that has to be pulled up as you
move the slider into position. Release the pin when the indicator is within
the 0 to 9 range.
3. Test the seat slide for proper operation and full travel.
Pro & Elite Only
1. Unscrew the seat slider pin far enough to allow the slider to pass over the
pin.
2. Tighten screw with the slider within the usable range.
3. Test the seat slide for proper operation and full travel.
Installation of the Pedals
NOTE: The pedal shafts are marked “R” and “L”. Trying to install the pedals on the wrong side may damage
the pedal and the crank arm. Take caution to attach the pedals to the correct side of the bike (picture shown is
for Elite/NXT).
1) Install the pedals on the pedal cranks using a 15mm open-end
wrench and tighten securely.
2) Turn the left pedal spindle counterclockwise when threading into
the left crank arm; turn the right pedal spindle clockwise when
threading into the right crank arm.