Filter
Top Products
Page 1 of 9Star Trac Product Support 800-503-1221
Page 1 of 9
Installation Instructions AS SETUP
SPIN BIKE ASSEMBLY AND SETUP
Use the following procedures to unpack and assemble your STAR TRAC SPINNER ® BIKE.
Prepare the area that you will be unpacking and assembling the bike to be free from debris that may cause
damage. Observe all safety precautions and care while unpacking and assembling the bike.
UNPACKING
Open the shipping carton, carefully remove all parts from the shipping carton and foam inserts, inspect all
packaging material for parts or screws and verify that the following parts are included in your shipment:
NXT Parts List
Description Qty. Description Qty.
Handlebar Post 1 M10x1.5, 55mm Button Head Screw 4
Handlebar 1 M10x1.5, 65mm Button Head Screw 4
M8x1.25, 16mm Flat Head Screw 2 M10x1.5 Nyloc Hex Nut 8
M8x1.25, 16mm Socket Set Screw 1 10mm Washer, Flat 16
Seat Post 1 Wrench Hex, 5mm 1
Seat Slider Assy, with Saddle 1 Wrench Hex, 4mm 1
Pedal set 1 set Multi Wrench 1
Front Leg Assy. With Transport Wheels 1 Spare Parts Kit (USA Only) 1 Kit
Rear Leg Assy. 1
Pro/Elite Parts List
Description Qty. Description Qty.
Handlebar Assy. 1 M10x1.5, 55mm Flat Head Screw 4
Seat Post 1 M10x1.5 Nut 4
Seat Slider Assy, with Saddle 1 10mm Washer, Flat 4
Pedal Set 1 set Wrench Hex, 5mm 1
Front Leg Assy. With Transport Wheels 1 Wrench Hex, 4mm 1
Rear Leg Assy. 1 Multi Wrench 1
Spare Parts Kit (USA Only) 1 Kit
Spare Parts Kit- Save the box of spare parts in a safe place so you have service parts when needed in the
future. The spare parts kit contains a spare saddle, brake pad and pedals straps. These items are not included
in the parts warranty.
NOTE: If you are missing any of the parts listed above, inspect the packing material and the box for items that
may have been overlooked.
If parts are missing, or if you have any product questions, please call Star
Trac’s Service Department at (800) 503-1221, please have your Spinner
serial number ready.
CAUTION: Damage to the bike during assembly is not covered as part of the
limited Star Trac warranty. Take care not to drop or lean the bike on the
handle bar pop pin. Carefully stand the bike up in the normal upright position
on a stable surface so it will not tip over during assembly.