Filter
Top Products
48
620-7991 Rev 002
Headphone Jack Replacement.
When you are experiencing poor audio output from your PVS, you should check the entertainment head-
phone jack to see if it needs replacement. The headphone jack was designed for an easy and quick replace-
ment.
Before you begin, make sure your have the proper replacement part available.
For the E-TR, use part number 715-3668.
For the E-TRx, use part number 715-3722.
For the E-TBTi, E-STi, E-RBi, and E-UBi use part number 718-5098.
For the E-TR Model:
1. Use a #2 Phillips screwdriver to remove the screw
that
holds in the headphone jack at the lower front of the
display.
2. Gently pull the headphone jack out of the display. Be care-
ful, the headphone is connected to a cable.
3. Disconnect the cable.
4. Connect the new headphone jack to the cable in the jack
opening.
5. Slide new headphone jack into the display plastic front.
6. Using the screwdriver, re-install the screw.
For the E-TRx Model:
1. Use a #2 Phillips screwdriver to remove the screw that
holds the headphone jack at the lower front of the hot bar.
2. Gently pull the Headphone jack out of the hot bar.
3. Slide new Headphone jack into the headphone opening.
4. Using the screwdriver, re-install the screw.
For the E-TBTi, E-STi, E-RBi, and E-UBi Models:
1. Use a #2 Phillips screwdriver to remove the screw
that
holds in the Head Phone Jack at the lower front of the
display.
2. Gently pull the Headphone jack out of the display. Be
careful, the headphone is connected to a cable.
3. Disconnect the cable.
4. Connect the new headphone jack to the cable in the jack
opening.
5. Slide new headphone jack into the display plastic front.
6. Using the screwdriver, re-install the screw.
This completes the Headphone replacement.