Filter
Top Products
21
620-7991 Rev 002
STEP 10. (E-TRx ONLY)
Take the E-TR headphone jack from the PVS
kit. Disassemble the headphone jack. Retain
the screw and the board.
Take the entertainment center console from the
PVS Kit. Flip it over so you are looking at the
back side.
Mount the headphone jack board to the center
console using the screw from earlier.
NOTE: The headphone jack must be mounted as
seen to reduce interference.
Once the center console has been mounted
into the display connect the head phone jack to
the appropriate jack as noted.
STEP 9.
Take the entertainment center console from the
PVS Kit.
1
2
STEP 8.
Now that the PVS is mounted onto the tread-
mill, you need to route the wires to their proper
places:
•
Take the coax cable and feed it all the
way down the treadmill neck.
•
Feed the DC power cable from the tread-
mill neck through the center console hole.
(E-TR ONLY)
•
Next take the headphone jack cable
from the PVS neck and connect it to the
headphone jack.
•
Now feed the other (3) cables through
the display and out the center console hole.
3
4