Filter
Top Products
19
620-7991 Rev 002
STEP 3. (E-TRx ONLY)
Note: If you have an E-TR skip this step.
Using a #2 Phillips screwdriver, remove the
screw that holds in the blank headphone jack
cap at the lower front of the Hot Bar. Retain the
screw.
You will no longer need the cap and, if desired, you
can store it away for any possible future use.
Now take the headphone jack from the iPod®
CC hardware kit. Connect the headphone jack
to the cable in the jack opening. Use the previ-
ously retained screw to reinstall the headphone
jack. Tighten snugly.
Skip ahead to Step 5.
STEP 1.
Using a #2 Phillips screwdriver, remove the (8)
screws from the upper back of the display.
Place the cover somewhere safe to keep it from
being damaged. Next, remove the (6) screws
from the lower back of the display. Place the
cover with the other one. Retain all the screws
for later use.
STEP 2.
Now remove the upper cap cover that has the
STAR TRAC logo on it. This cap is held in by
the upper back cover.
You will no longer need this cap cover and, if de-
sired, you can store it away for any possible future
use.
I
NSTALLING
Y
OUR PVS
O
N
T
HE
E
-TR
A
ND
E
-TRx