Filter
Top Products
ASSEMBLY INSTRUCTIONS
9
STEP 9: There is a "L" decal on the LEFT HANDLEBAR(7), and a "R" decal on the RIGHT HANDLEBAR(8).
To assemble the RIGHT HANDLEBAR(8), place a SPACER(56) and a LARGE WASHER(M16)(57) onto
the right side of the SHAFT on the UPRIGHT(6). Slide the RIGHT HANDLEBAR(8) onto the SHAFT and
secure with a LARGE WASHER(M8)(48), LOCK WASHER(M8)(91), and BUTTON HEAD BOLT
(M8x1.25x20mm)(66). Repeat on the left side.
STEP 10: Attach the LOWER PIVOTING ARMS(9) to the LEFT and RIGHT HANDLEBARS(7, 8) with
HEX BOLTS(M6x1x38mm)(73), ARC WASHERS(M6)(88), LOCK WASHERS(M6)(90), and ACORN NUTS
(M6x1)(86). The HEX BOLTS(M6x1x38mm)(73) fit inside the hex-shaped holes in the HANDLEBARS
(7, 8). Attach the LOWER PIVOTING ARMS(9) to the LINKAGES(10) at both sides with the PLASTIC
WASHERS(M8)(53), BUTTON HEAD BOLTS(M8x1.25x48mm)(67), and NYLOCK NUTS(M8x1.25)(80).
STEP 11: Look down from the top of the UPRIGHT(6) to make sure the pivot tubes on the HANDLEBARS
(7, 8) are parallel to the FRONT STABILIZER(2) and the PEDAL ARMS(4, 5) are crossing the ROLLERS(60)
properly. Tighten the BUTTON HEAD BOLTS(M8x1.25x15mm)(65) on the UPRIGHT(6).
Shaft
Look down from the top
L
R