Filter
Top Products
SET UP INSTRUCTIONS
11
Place the CT2.0 CROSS TRAINER in the area where it will be used. It is recommended that the CT2.0
CROSS TRAINER be placed on an equipment mat. The maximum operation dimensions of the CT2.0
CROSS TRAINER are approximately 41 1/2" long x 21 1/4" wide x 57 3/4" tall. (These dimensions may vary
up to one inch.) An area 4 feet wide x 6 feet long is required for safe operation of the CT2.0 CROSS
TRAINER. Make sure that adequate space is available for access to and passage around the CT2.0 CROSS
TRAINER.
Adjust the LEVELING CAPS(63) on the REAR STABILIZER(3) so that the CT2.0 CROSS
TRAINER sets on the floor without rocking.
Grasp the pivot tubes on the HANDLEBARS(7, 8) and REAR STABILIZER(3) to move the
CT2.0 CROSS TRAINER, two people are required for moving. Do not use the Pedal Arms to
move the CT2.0 CROSS TRAINER. The Pedal Arms will move and may pinch your hand or
fingers.
LEVELING:
MOVING:
FUNCTION INSPECTION:
Visually inspect the CT2.0 CROSS TRAINER to verify that assembly is as shown in the above illustration.
Check the function of the CT2.0 CROSS TRAINER. Stand on the foot pedals and place your hands at a
comfortable position on the handlebars. Slowly move your highest foot forward and follow the natural path of
the machine. Complete one full revolution slowly to verify that the drive train functions properly. Adjust the
TENSION KNOB(32) and verify that it functions properly.
Locate and read the WARNING LABEL(92) on the CT2.0 CROSS TRAINER. Make sure that
all users read the WARNING LABEL(92).
Equipment Mat
CAUTION:
Grasp here to move
Grasp here to move