Filter
Top Products
SET UP INSTRUCTIONS
12
Equipment Mat
Grasp here
Grasp here
FUNCTION INSPECTION:
Visually inspect the AVARI® Magnetic Elliptical to verify that assembly is as shown in the above illustration.
Check the function of the AVARI® Magnetic Elliptical, stand on the PEDAL CAPS(30, 31) and place your
hands at a comfortable position on the HANDLEBARS(3, 5). Slowly move the crank through one complete
revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(8) and verify that it
functions properly and the resistance changes.
CAUTION: Locate and read the WARNING LABEL(78) on the AVARI® Magnetic Elliptical. Make sure
that all users read the WARNING LABEL(78) before using the product.
LEVELING: Adjust the LEVELING CAPS(18) on the REAR STABILIZER(77) so the AVARI® Magnetic
Elliptical sits on the oor without rocking. Remove and reposition the LEVELING CAPS(18)
on the REAR STABILIZER(77) to level the AVARI® Magnetic Elliptical.
MOVING: The AVARI® Magnetic Elliptical must be lifted to be moved. Two people are required to
grasp the Pivoting Shaft area and the REAR STABILIZER(77), lift and move.
Place the AVARI® Magnetic Elliptical in the area where it will be used. It is recommended that the AVARI®
Magnetic Elliptical be placed on an equipment mat. The maximum operation dimensions of the AVARI®
Magnetic Elliptical are approximately 46.9 inches long x 22 inches wide x 59.1 inches tall. (These dimensions
may vary up to one inch.) Make sure that adequate space is available for access to move around and
emergency dismount from the AVARI® Magnetic Elliptical. A minimum of 20 inches on at least one side
and 20 inches either behind or in front of the AVARI® Magnetic Elliptical is required for safe operation.