Filter
Top Products
ASSEMBLY INSTRUCTIONS
STEP 4
The BUTTON HEAD BOLTS(M8x1.25x15mm)(38) are attached on the LEFT and
RIGHT UPRIGHT
(2, 3). Refer to detail view B. Tighten the BUTTON HEAD BOLTS(M8x1.25x15mm)(38) to bolt the LEFT
UPRIGHT(2), RIGHT UPRIGHT(3), and CONNECTING BAR(7) together securely. Please verify that
the SENSOR WIRE(28) and SENSOR CONNECTING WIRE(27) have already been connected at the
factory. If it has not been pre-connected, then please plug the SENSOR WIRE(28) into the SENSOR
CONNECTING WIRE(27) at this time.
STEP 5
Insert the LEFT HANDRAIL(5) into the RIGHT HANDRAIL(6) and secure with the ROUND HEAD
BOLT(M6x1x15mm)(42). Attach the HANDRAIL ASSEMBLY(5, 6) to the LEFT and RIGHT UPRIGHT(2,
3) with BUTTON HEAD BOLTS(M8x1.25x40)(37) and ARC WASHERS(M8)(51).
STEP 6
Plug the SENSOR CONNECTING WIRE(27) into the METER CONNECTING WIRE(26). Push the wires
back inside of the RIGHT UPRIGHT(3). Press the HANDRAIL CAPS(19) onto the LEFT and RIGHT
HANDRAILS(5, 6) to cover the top ends of the LEFT and RIGHT UPRIGHT(2, 3).
8
B.