Filter
Top Products
The safety and integrity designed into the AeroPilates® Performer 286 can only be maintained when
the AeroPilates® Performer 286 is regularly examined for damage and wear. Special attention should
be given to the following:
STORAGE
MAINTENANCE
10
1. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
2. Worn or damaged components should be replaced immediately or the AeroPilates® Performer 286
should be removed from service until repair is made.
3. Verify that the WARNING LABEL(50) is in place and easy to read. Call Stamina Products
immediately at 1-800-375-7520 for a replacement WARNING LABEL(50) if it is missing or damaged.
4. Verify that the ROPES(18) are properly installed on the PULLEY SETS(22).
5. Check the condition of the ROPES(18) and replace if they are frayed or worn.
6. Check the PLASTIC SNAP HOOKS(19) on the ends of the ROPES(18). Replace the PLASTIC
SNAP HOOKS(19) if they are damaged or deformed.
7. Check the TENSION CORDS(10). If any of the TENSION CORDS(10) are stretched and loose, re-tie
the knot on the end of the cord. Replace TENSION CORDS(10) that are frayed or worn.
8. Check the PULLEY SETS(22) for excessive wear. Replace worn PULLEY SETS(22).
9. Check the HAND STRAPS(20) for damage. Replace damaged parts.
10. Check the FOAM SLEEVE(6) and FOAM PADS(17) and replace if damaged or worn.
11. Check the STOP PLATES(27, 29) for looseness or damage and replace any damaged parts.
12. Check the CUSHION(14) and replace if it is damaged or worn.
13. Check and clean the ROLLERS(8) and the rolling surfaces on the rails. Clean by wiping with a dry
cloth.
14. Only Stamina Products supplied components shall be used to maintain/repair the AeroPilates®
Performer 286.
15. Keep your AeroPilates® Performer 286 clean by wiping it off with an absorbent cloth after use.
1. To store the AeroPilates® Performer 286, simply keep it in a clean dry place.
2. The FRONT FRAME(1) of the AeroPilates® Performer 286 has built-in wheels for easy moving. To
move, be sure at least one of the tension cords is attached to prevent the CARRIAGE(7) from sliding,
then lift from the end of the REAR FRAME(2) and roll.
3. The AeroPilates® Performer 286 folds for storage. To fold, be sure no tension cords are attached
and slide the CARRIAGE(7) to the end of the REAR FRAME(2). Remove the FOOTBAR(5) and
FOAM PAD ASSEMBLIES(17), then lift the AeroPilates® Performer 286 onto its side with the
LOCKING PIN(26) side up. With the machine hinging in the middle, move the FRONT FRAME(1)
toward the REAR FRAME(2) until the frame ends meet. Insert the LOCKING PIN(26) into the hole in
the REAR FRAME(2), and the AeroPilates® Performer 286 is ready to store.