Filter
Top Products
15
STORAGE
MAINTENANCE
Check the angle adjustment tube, traction bars, ball pins, pivot arms, cushion bed, heel holders, foam
pads, spring pin, and warning label for
damage and wear.
Replace damaged and worn components immediately and/or keep the equipment out of use until repairs
are complete.
1.
2.
The safety level of the Elite Inversion System can be maintained only if it is examined regularly for
damage and wear.
The Elite Inversion System is designed to fold for easy storage. You can store
your
Elite Inversion System as illustrated. Please follow the following process:
When folding and unfolding the Elite Inversion System, keep all children away from the
Elite Inversion System and make sure your hands are clear of any folding or pinch point.
Lowest
Adjustment Hole
1.
WARNING:
3.2.
STEP 1: Loosen LOCKING KNOB(36) and pull out the
SPRING PIN(35). Now, slide the HEIGHT ADJUSTMENT
BEAM(10) into the MAIN FRAME(92) and lock in the lowest
adjustment hole. Refer to illustration 1.
STEP 2: Remove the PULL PINS(86) from the ANGLE
ADJUSTMENT BARS(85). Swing the NYLON BED(37)
down to about the same place as the Rear Frame and lock in
position by inserting the
PULL PINS(86) into the second
adjustment holes in the
ANGEL ADJUSTMENT BARS(85)
above the SUPPORT SLEEVE(84). Refer to illustration 2.
STEP 3: Remove the LONG BALL PINS(46) from the
REAR FRAMES(2, 3). Fold the Front Frame close to the
Rear Frame as Illustration 3 shows. Insert the
LONG BALL
PINS(46) back into the REAR FRAMES(2, 3) to lock the
Elite Inversion System in the folded position.
Insert the PULL PINS(86)
into the second
adjustment holes.