Filter
Top Products
OPERATIONAL INSTRUCTIONS
HEEL HOLDER USE AND ADJUSTMENT
Place your feet on the FOOTREST(11) with your ankles between the
HEEL HOLDERS(15) and FOAM PADS(18).
The HEIGHT ADJUSTMENT BEAM(10) includes a LEVER(23) to
grip and release your feet. Pull the
LEVER(23) toward you until your
ankles are securely held between the
HEEL HOLDERS(15) and
FOAM PADS(18).
To release your feet or relax the grip, pull the LEVER(23) toward you
slightly and press the button on the end of the lever.
1.
2.
3.
Button
THE HANDRAILS
INVERSION ANGLE ADJUSTMENT
There are 11 adjustment holes in the ANGLE
ADJUSTMENT BARS(85) allowing you restrict the
movement of the
NYLON BED(37) to different angles
by inserting the
PULL PINS(86) into different
adjustment holes.
The top holes will allow the least amount of inversion
angle. The lowest hole will allow the greatest amount of
inversion angle and the
Elite Inversion System will
go into the full inversion position.
1.
2.
Use the holes near the top in the ANGLE
ADJUSTMENT BARS(85) until you become
familiar with the
Elite Inversion System.
Both PULL PINS(86) must be inserted into the same
hole in the
ANGLE ADJUSTMENT BARS(85).
Trying to insert the PULL PINS(86) into different
positions could cause damage to the machine, and
injury to the user.
CAUTION:
For added convenience, and safety, a set of HANDRAILS has been added to the Elite Inversion System.
These HANDRAILS are located at both sides of the frame. The HANDRAILS are to help you return to
the upright position from any degree of inversion. If you wish to return to the upright position, and the bed
is moving too slowly, or not moving at all, simply grab the
HANDRAILS and pull on them until you return to
the upright position.
12