Filter
Top Products
ASSEMBLY INSTRUCTIONS
10
STEP 10
Install the HEIGHT ADJUSTMENT BEAM(10) into MAIN FRAME(92) by pulling the SPRING PIN(35)
on the MAIN FRAME(92) and inserting the HEIGHT ADJUSTMENT BEAM(10) as shown. For added
safety, thread the
LOCKING KNOB(3/8"-16 x 3/4")(36) into back side of the MAIN FRAME(92).
WARNING:
Do not use the Elite Inversion System until you have verified your height setting. Failure
to use the proper height setting can result in difficulty recovering from the decline position.
See
HEIGHT ADJUSTMENT instructions on page 11.
STEP 11
Insert the front ends of the HANDRAILS(5) onto the short tubes on REAR FRAMES(2, 3). Then attach
the back ends of the
HANDRAILS(5) with BOLTS(M8 x 50mm)(63) and WASHERS(M8)(69).