Filter
Top Products
STEP 4
Remove the paper covering from the foam tape inside the FRONT COVER(3) and REAR COVER(4).
Place the FRONT COVER(3) over the FRONT FRAME(1). Place the REAR COVER(4) over the
REAR FRAME(2). Press the covers securely in place.
NOTE:
7
ASSEMBLY INSTRUCTIONS
SUPPORT
BRACKET
The securing SCREWS(M6 x 35mm)(35) for the PULLEY ASSEMBLY(19) on each side may
need to be loosened to allow the
REAR COVER(4) to fit securely over the frame. Refer to the
inset illustration. When retightening the screws for the
PULLEY ASSEMBLY(19) do not over
tighten. The
PULLEY ASSEMBLY(19) should move freely.
STEP 5
Insert the FOOT REST(5) into the mounting holes located on the FRONT FRAME(1). The FOOT
REST(5) should pass through the FRONT COVER(3) and the FRONT FRAME(1).
STEP 6
Insert the FOAM PAD ASSEMBLIES(14) into the holes located on the CUSHION ASSEMBLY(7).
STEP 7
The HEAD REST(12) on the CUSHION ASSEMBLY(7) can be positioned at an incline by simply pivoting
the
SUPPORT BRACKET underneath the HEAD REST(12).