Filter
Top Products
7.
6.
Flute
Tip
ASSEMBLY INSTRUCTIONS
STEP 7
Loosen the LOCKING KNOB(19) on the SENSOR
DETECTOR(23) to allow the FLUTED LEG(6) to slide
through the hole in the SENSOR DETECTOR(23). Slide
the SENSOR DETECTOR(23) on the FLUTED LEG(6) and
slide up until the SENSOR DETECTOR(23) snaps into the
ute. Adjust the position of the SENSOR DETECTOR(23)
so that the tip is slightly touching the bottom of the MAT(3).
Be sure the SENSOR DETECTOR(23) is not pressed rmly
against the bottom of the mat or bent downward. If it is not
adjusted correctly, there is a chance that the SENSOR
DETECTOR(23) won’t work properly or that the arm will
break during use. Lock the SENSOR DETECTOR(23) in
position with the LOCKING KNOB(19). Press the LEG
CAP(7) on the FLUTED LEG(6).
STEP 8
Install an AA battery into the METER(22), battery is not
included. See page 14 for detailed battery installation
instructions. Slide the METER(22) onto the MOUNTING
BRACKET(24). Plug the sensor wire on the SENSOR
DETECTOR(23) into the back of the METER(22).
STEP 6
Insert both ends of the TOP HANDRAIL(13) into
the HANDRAILS(15) and lock with the BUTTON
PINS(14). Insert the HANDRAILS(15) into the HANDRAIL
SUPPORTS(16) and lock in position with the ADJUSTMENT
KNOBS(18).
NOTE: There are marks on the HANDRAILS(15) to help
to set the height of the handrail.
9
Mark
Button Pin(14)