Filter
Top Products
ASSEMBLY INSTRUCTIONS
7
STEP 3
Slide the SEAT(54) onto the RAIL(1). Attach the REAR STAND(2) onto the RAIL(1) with HEX HEAD
BOLTS(M8 x 15mm)(70).
NOTE:
STEP 4
Remove the LOCKING KNOB(44) from the SUPPORT FRAME(4). Remove the PULL PIN(43) from
the
RAIL(1). Unfold the FAN ASSEMBLY by swinging the SUPPORT FRAME(4) toward the front.
Refer to the inset drawing. If it is difficult to slide the
SEAT(54) onto the RAIL(1), turn the
NYLOCK NUT(M6)(75) located on the SEAT CARRIAGE(55) counter-clockwise to adjust
the position of the Roller lower.
If the
SEAT(54) rocks on the RAIL(1), turn the NYLOCK NUT(M6)(75) located on the SEAT
CARRIAGE(55) clockwise to tighten the Roller.
1.
2.
Roller
Fan Assembly