Filter
Top Products
CARDIO 630 HEART RATE MONITOR
6 7
TIME
• AM, PM, hour, minute,
second
• 12/24 hour format
• Calendar: month, date,
day display with auto leap
year adjustment
ALARM
• Daily alarm
• Alarm duration: 30
seconds
CHRONOGRAPH
• Resolution: 1/100 second
• Measuring range: 23
hours, 59 minutes, 59.99
seconds
HEART RATE
• Range: 30-240 beats per
minute
• Measuring range: 23
hours, 59 minutes, 59.99
seconds
• Calorie Tracking Range:
0-9999
• Fat Burn range: 0 - 1296 g
OTHER
• Electroluminescent (EL)
backlight
• Water resistant up to 50
meters
• Battery: CR 2032 3v (X2)
FUNCTIONS
ACTIVATING THE MONITOR FROM POWER SAVE MODE
In order to conserve battery life, this monitor was shipped in
Power Save mode. To activate the monitor, PRESS & HOLD ANY
KEY for 5 seconds.
The device complies with Part 15 of the FCC Rules. Opera-
tion is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
Changes or modifi cations not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the product.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the transmitting equip-
ment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio technician for
help.
FCC COMPLIANCE
SP1448IS01SPO.indd 6-7SP1448IS01SPO.indd 6-7 6/10/11 12:19 PM6/10/11 12:19 PM