Filter
Top Products
34
Belt and Bed - Your treadmill uses a very high-efficient low-friction bed. Performance is
maximized when the bed is kept as clean as possible. Use a soft, damp cloth or paper towel to
wipe the edge of the belt and the area between the belt edge and frame. Also reach as far as
practical directly under the belt edge. This should be done once a month to extend belt and bed
life. Use water only - no cleaners or abrasives. A mild soap and water solution along with a nylon
scrub brush will clean the top of the textured belt. Allow to dry before using.
Belt Dust - This occurs during normal break-in or until the belt stabilizes. Wiping excess off with a
damp cloth will minimize buildup.
General Cleaning - Dirt, dust, and pet hair can block air inlets and accumulate on the running belt.
On a monthly basis, vacuum underneath your treadmill to prevent buildup. Once a year, you
should remove the black motor hood and vacuum out dirt that may accumulate. UNPLUG POWER
CORD BEFORE THIS TASK.
BELT ADJUSTMENTS:
Treadbelt Tension Adjustment - Belt tension is not critical for most users. It is very important for
joggers and runners in order to provide a smooth, steady running surface. Adjustment must be
made from the right side of the rear roller in order to adjust tension with the 6 mm Allen wrench
provided in the parts package. The adjustment bolt is located at the end of the right side rail as
noted in diagram below.
Tighten the rear roller only enough to prevent slippage at the front roller. Turn the treadbelt tension
adjusting bolt in increments of 1/4 turn and inspect for proper tension.
When an adjustment is made to the belt tension, you must also make a tracking
adjustment to compensate for the change in belt tension. This is accomplished by turning right
and left tension and tracking Allen bolts an equal amount. This adjusment should be made by turning
both bolts clockwise by no more than a 1/4 turn at a time.
DO NOT OVERTIGHTEN – Over tightening will cause belt damage and premature bearing failure.
General Maintenance
Note:
A
djustment is through small hole in end
Tracking / Tension
A
djustment
Tracking / Tension
Adjustment