Filter
Top Products
XT285 Treadmill
5
!!ATTENTION: IMPORTANT UNPACKING INSTRUCTIONS. PLEASE
READ BEFORE UNPACKING YOUR FOLDING TREADMILL!!
Serious injury could occur if this folding treadmill is not unpacked properly.
There is a Velcro strap installed around the treadmill base that prevents the treadmill
from unfolding accidentally during shipping. If this strap is not removed properly the
treadmill could spring open unexpectedly and cause injury if someone is standing near
the treadmill when the strap is removed.
To ensure your personal safety during removal of the shipping strap please make sure
the treadmill is positioned at on the ground, in the orientation it would be in if you
were using the treadmill. Do not turn the treadmill up on its side while removing the
shipping strap. This could cause the treadmill’s folding mechanism to spring open. If
the end of the Velcro strap (that you need to grab to remove it) happens to be under
the treadmill deck, reach under the deck to grab it, but do not tilt the treadmill up to
gain access to the strap end.
Cut the banding straps with a short box cutter (razor knife); separate the carton from
the one underneath it by prying up on the staples (if applicable). Pull the carton over
the treadmill parts and locate the hardware pack. The hardware pack is separated into
ve sections; one section containing tools and four sections labeled steps 1-4 which
contain the hardware needed for assembly of each step. The assembly steps below
are numbered one through four and correspond to the hardware in the numbered
sections of the hardware pack. Remove only the hardware for the step you are
currently assembling to avoid confusion and mix ups.
Then remove the treadmill from the carton and lay it on a level surface.
XT285 ASSEMBLY INSTRUCTIONS
ASSEMBLY TOOLS
#96. Combination M5 Allen Wrench/
Phillips Head Screw Driver
#97. M6 Allen
Wrench
#33. Safety Key
#58. Deck/Belt
Lubricant
#122. Phillips Head Screw Driver