Filter
Top Products
XT285 Treadmill
24
Do not lubricate with other than Spirit approved lubricant. Your
treadmill comes with one tube of lubricant and extra tubes can
be ordered directly from Spirit or your authorized Spirit dealer.
There are commercially available lube kits, but the only one
currently approved by Spirit is Lube-N-Walk.
These kits come with an application wand that makes applying
the lubrication easier. The kits can be purchased directly from
Lube-N-Walk here: http://www.jadtness.com/. The proper kit
should be silicon based, NOT parafn wax.
Keeping the deck lubricated at the recommended intervals ensures the longest life possible
for your treadmill. If the lubricant dries out, the friction between the belt and deck rises and
places undue stress on the drive motor, drive belt and electronic motor control board, which
could result in catastrophic failure of these expensive components. Failure to lubricate the
deck at regular intervals may void the warranty.
The belt & deck come pre-lubricated and subsequent lubrication should be
performed every 180 hours of use. The console has a built in lubrication reminder indicator
that lights every 180 hours of use.
Use the Lubricant to lubricate the deck beneath the belt. If you can reach under the belt
approximately 6” on each side, use the following procedure: Unplug the electrical cord.
Towards the middle of the deck (about 18” from the edge of the motor cover), lift up on the
belt and reach under with the tube of lubricant. Squirt half of the lubricant on the deck
surface in a line (parallel to the motor cover) spanning the 6”. Repeat the process on the
opposite side. Plug the electrical cord back into the outlet and walk on the belt at a
moderate speed for ve minutes.
If unable to perform the above procedure, it will be necessary to loosen the walking belt.
Using the 6 mm Allen wrench supplied, loosen the two rear roller adjustment bolts -- located
in the rear end caps – enough to get your hand under the belt (5 –10 turns). Make sure to
loosen both bolts the same amount of turns and also remember how many turns, because
when nished you will need to tighten the bolts back to the point they were before.
Once the belt is loose, wipe the deck with a clean lint free cloth to remove any dirt. Apply
the whole tube of lubricant onto the deck surface about 18 inches from the motor cover.
Squeeze out the contents of the tube across the deck (parallel to the motor cover) in about
a one-foot line, like toothpaste on a toothbrush. The one-foot line should be in the middle
of the deck at approximately equal distance from both side edges of the belt. You want the
lubricant to be applied about the spot that your feet would hit the belt as you are
walking. This should be about 18 inches from the motor cover, but you may want to walk on
the treadmill before loosening the belt to note where your feet land on the belt. If you mostly
use the treadmill for running, the spot where your feet land may be different from walking.
Once the lubricant is applied, tighten the rear roller bolts the same amount of turns as when
you loosened them. Run the treadmill at about 3 mph without walking on it for about a
minute or two to make sure the belt stays in the middle of the deck. If the belt tracks to one
side then follow the belt tracking instructions to remedy. Now the deck is lubricated and
you should walk, not run, on the treadmill immediately for at least 5 minutes to ensure the
lubricant is evenly distributed. If you purchase a silicone based Lube-N-Walk kit, follow the
instructions that come with it to apply the lubrication.
BELT/DECK LUBRICATION PROCEDURE