Filter
Top Products
CT800
-7-
Step 1: Upright Tubes
• The right side upright tube (19) has the computer cable (A) pre-installed. Lift the tube off the
walking surface and attach it to the base frame. You need to gently pull on the computer
cable as you line up the upright tube, taking the slack out, so the cable does not get pinched
between the tube and the base frame. Assemble one 3/8 x 3-3/4 bolt (108), 3/8 split
washer (58) and 3/8 flat washer (59) through the top hole in the retaining plate (21), and
corresponding top hole in the upright tube, and screw into the base frame. Now install the
other two bolts (108) and washers (58 & 59) and tighten all three securely.
• Install the left upright (18) in the same manner.
• Install the lower side caps (32 & 33) with four M5 x 12mm screws (77).
Assembly Instructions