Filter
Top Products
3. While lifting the side of the walking
belt, position the spray nozzle
between the walking belt and the
board approximately 6" from the front
of the treadmill. Apply the silicone
spray to the walking board, moving
from the front of the treadmill to the
rear. Repeat this on the other side
of the belt. Spray approximately 4
seconds on each side.
4. Allow the silicone to "set" for 1
minute before using the treadmill.
-27-
maintenance
MAINTENANCE INSTRUCTIONS
WARNING! Before performing any
maintenance to your treadmill,
always unplug the power cord from
the surge protector.
CLEANING:
Routine cleaning of your treadmill
will extend the product's life.
Warning! To prevent electrical
shock, be sure the power to the
treadmill is OFF and the unit
unplugged from the wall electrical
outlet before attempting any
cleaning or maintenance.
After each workout: Wipe off the
console and other treadmill
surfaces with a clean, water
dampened soft cloth to remove
excess perspiration.
IMPORTANT: Never use abrasives
or solvents to clean the treadmill.
To prevent damage to the
computer, keep liquids away and
keep it out of direct sunlight.
Weekly: Use of a treadmill mat is
recommended for ease of cleaning.
Dirt from your shoes contacts the
belt and eventually makes it to
underneath the treadmill. Vacuum
underneath treadmill once a week.
DECK LUBRICATION:
The walking belt has been pre-
lubricated at the factory. However,
it is recommended that the walking
board be checked periodically for
lubrication to ensure optimal treadmill
performance. Your treadmill should
not have to be lubricated usually
within the first year or 500 hours of
use. Call your local Smooth dealer
for service or questions regarding
EVO products.
Every 30 days or 30 hours of
operation, lift the sides of the walking
belt and feel the top surface of the
walking board as far as you can
reach. If you feel signs of silicone,
no further lubrication is required. If
it feels dry to the touch, follow the
instructions below.
Please use Lube 'N Walk (can be
purchased from your dealer or call
the number on the front of the
manual), or a non-petroleum based
silicone such as "Napa 8300"
(available at most stores).
To apply lubricant to the walking
belt:
1. Position the walking belt so that
the seam is located on top and in
center of the walking board.
2. Insert the spray nozzle into the
spray head of the lubricant can.
SPRAY FROM
FRONT TO BACK