Filter
Top Products
LED 17 COMPUTER INSTRUCTIONS
8
MOTION CONTROL OPERATION
How to use MOTION CONTROL
(
Note:
p
hotos ma
y
var
y
from actual treadmill
)
:
1. Press the button on the console to switch the motion control
function on and off:
• When the LED light is ON the MOTION CONTROL is active.
• When the LED light is OFF the MOTION CONTROL is off.
2. After switching on the MOTION CONTROL wave your right hand
approximately 6 inches above the motion sensor on the right
handle bar to increase the speed. The sensor will sound one
short BEEP per scan and speed up by 0.1 MPH per BEEP.
Holding your right hand approximately 6 inches above the right
sensor constantly results in the sensor sounding one long BEEP
per second and speeding up by 0.1 MPH per BEEP.
2. Use right sensor to speed up.
3. Wave you left hand approximately 6 inches above the motion
sensor on the left handle bar to decrease the speed. The sensor
will sound one short BEEP per scan and decrease speed by 0.1
MPH. Holding your left hand approximately 6 inches above the
left sensor constantly results in the sensor sounding one long
BEEP per second and decreasing speed by 0.1 MPH per BEEP.
3. Use left sensor to slow down.
4. Wave both hands approximately 6 inches above both motion
sensors at the same time. The sensor will sound two short
BEEPs then stop the belt.
• Always switch off the MOTION CONTROL function by
pressing the
button before turning off the power to the
treadmill.
4. Use both sensors to stop belt.