LED 17 COMPUTER INSTRUCTIONS
6
COMPUTER OPERATION
5K SELF LEARNING/COMPETITION:
When the treadmill is in PROGRAM SELECT status, press the
button. Then you have to select the user code. After
completed the user profile setup, the DISTANCE LED will show 5(KM)/3(MILE). For new users, there is a pre-set speed and
incline% program in the computer. Press the START button to start the program. The user can change the speed and incline
level during the workout. The DISTANCE will count down to zero then stop. The result time and calories will be saved and
shown on the display so the user can select this program again and to challenge himself using the same program.
HEART RATE CONTROL:
When the treadmill is in PROGRAM SELECT status, press the
button. Then you have to select the user code. After
completed the user profile setup, the TIME LED will show a blinking pre-set workout time of 60:00. Press the INCLINE
UP/DOWN button to adjust the workout time then press the ENTER button to confirm. Press the START button to start the
program. During the program please make sure to wear the chest belt or hold the hand pulse contact sensor on the handle
bar at all times. Exercising without chest belt or failure to hold the contact sensor will cause the program fail and discontinue.
WARM UP – After completing the TIME set up and starting the program, there is a 3 minute WARM UP program to help you
reach the minimum target workout heart rate. The speed will start from 2MILE/3.2KM and the incline level will start from 0. If
the actual pulse rate does not reach the minimum target workout heart rate, the speed will increase 0.5MILE/0.8KM every 15
seconds. When the actual pulse rate reaches the minimum target workout heart rate, the speed will stop increasing and
continue the same speed until the 3 minute warm up is complete and then go into the HEART RATE CONTROL main
program. If you cannot reach the minimum target workout heart rate in 3 minutes, the program will continue the 2
nd
3 minute
WARM UP program. During the 2
nd
WARM UP program, the speed will remain the same speed as in the first WARM UP
program. If the actual pulse rate cannot reach the minimum target workout heart rate, the incline level will add 1% every 15
seconds. When the actual pulse rate reaches the minimum target workout heart rate, the incline will stop changing and
continue the same speed and same incline level until the time counts down to zero then enters the HEART RATE CONTROL
main program. If during the 2
nd
WARM UP the user still can not reach the minimum target workout heart rate, the computer
will continue on to the 3
rd
WARM UP procedure for 3 minutes and both speed and incline level will be remain the same as the
2
nd
WARM UP until the time counts down to zero. If the 3
rd
WARM UP program still cannot bring up the actual pulse rate to
the minimum target workout heart rate, the program will stop and SPEED LED will show FAIL.
HEART RATE CONTROL MAIN PROGRAM – After the actual pulse rate reaches the minimum target workout heart rate and
completes the warm up program, the computer will go into the main program and the time will count down from the pre-set
time. During the main program, if the actual pulse rate cannot reach the maximum target workout heart rate, the incline level
will be increased by 1% every 15 seconds until the pulse rate reaches the maximum target workout heart rate or the incline
level will increase by 15%. After the incline level increases to 15% but still does not reach the maximum target workout heart
rate the speed will be increase by 0.5MILE/0.8KM every 15 seconds until the pulse rate reaches the maximum target workout
heart rate. If the actual pulse is higher than the maximum target workout heart rate, then the incline will be reduced 1% every
15 seconds until the actual heart rate meets the maximum target workout heart rate or the incline level will lower to 0%. Then
the speed will be reduced by 0.5MILE/0.8KM every 15 seconds until the actual pulse meets the maximum target workout
heart rate.
COOL DOWN – After completing the HEART RATE CONTROL program and the time counts down to zero start the one-
minute cool down program. The incline will return to 0% and the speed will lower to 2MILE/3.2KM as the time counts down
from 1:00.c