Filter
Top Products
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing matedals until assembly iscompleted.
THE FOLLOWING TOOLS ARE REQUIRED FOR ASSEMBLY: The Included 7/32" allen wrench
and your own adjustable wrench _:;;;:=:::::::_.
1. Insert the square end of one of the Upright Bushings (98) into
the square hole in the right side of the treadmill Frame (45).
Insert the other Upright Bushing into the hole in the left side of
the treadmill Frame (not shown).
98
45
2. With the help of a second person, raise the Right Upright (18)
and the Left Updght (not shown) to a vertical position. Align the
hole in the lower end of the Right Updght with the hole in the
side of the Frame (45). Insert an Upright Bolt (22), with a Flat
Washer (15), into the Right Upright, and tighten the Bolt into the
Frame. Tighten the Boltthat is already in the Right Upright.
Attach the Left Upright (not shown) in the same manner.
15
45
22
3. W'dhthe help of a second person, raise the Left and Right
Handrails (7, 14) as shown. Insert a Handrail Bolt (1) into each
• ofthe Uprights (3, 18), and tighten the Boltswith the 7/32" Allen
Wrench (71).
3
4. Remove the paper backing from the Wrench Clip (62). Press the
Wrench Clip onto the Frame (45) in the indicated location. Press
the 3/16" Allen Wrench (61) into the Wrench Clip.
Make sure that all parts are tightened before using the treadmill.
Note: Cover the floor underneath the treadmill for protection.
61
62
6