Filter
Top Products
SettheConsoleAssembly(91)facedownona
softsurfacetoavoidscratchingtheConsole
Assembly.HoldtheRightHandrail(33),which
hasa largeholeinoneside,neartheConsole.
Next,inserttheconsolewireandthetieintothe
holeinthesideof theRightHandrail(33).Using
needlenosepliers,pulltheconsolewireoutof
theholenearthebracketontheRightHandrail.
Then,settheRightHandrail(33)ontheConsole
Assembly(91).Makesurethatnowiresare
pinched.Startan M5x 16mmScrew(85)witha
M5StarWasher(7)intotheRightHandrail,and
thenstarttwoM4.2x 19mmScrews(10)intothe
RightHandrail.TightentheM5x 16ramScrew
andthentightenthetwoM4.2x 19ram
Screws;donotovertightentheScrews.
AttachtheLeftHandrail(notshown)to the
ConsoleAssembly(91)in thesameway.Note:
Therearenowiresontheleftside.
33
Console
Wire 85
Tie
91
10
RemovetheplastictiesfromtheRightHandrail
(33)andtheLeftHandrail(notshown).Withthe
helpofasecondperson,holdtheConsole
Assembly(91)neartheRightUpright(54).
RemovethewiretiefromtheWireHarness(39).
ConnecttheWireHarnesstotheconsolewire.
Seetheinset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON=
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON. Insert the connectors and the ex-
cess wire downward into the Right Upright (54).
54--
91
9. Attach the Console Assembly (91) to the Right
Upright (54) and the Left Upright (53) with four
M8 x 15mm Bolts (8) and four M8 Star Washers
(5). Make sure that no wires are pinched. Start
all four Bolts but do not tighten them yet.
91
5
9