Filter
Top Products
3.Withthehelpofasecondperson,holdtheConsoleBase
(6)andtheRightHandrail(32)neartherightUpright(14).
FeedallexcessWireHarness(26)downintotheright
Upright;ifnecessary,bendtheWireHarnessasshown.
RoutetheWireHarness(26)throughthebracketonthe
RightHandrail(32)asshown.Insertthebracketintothe
rightUpright(14).
Referto theinsetdrawing.PushtheStrainReliefClip(88)
ontotheWireHarness(26).Inserta 1/2"Screw(13)into
theStrainReliefClipandintotheindicatedholeinthe
RightHandrail(32).MakesurethatthereisnoslackWire
HarnessbetweentheStrainReliefClipandtheConsole
Base(6).TightentheScrewintotheConsoleBase.
IMPORTANT: The Strain Relief Clip (88) must be
attached as instructed,
4. Attach the Console Base (6) to the Left and Right
Handrails (2, 32) with three 1/2" Screws (13).
5. Thread a Handrail Bolt (15) with a Handrail Washer (16)
into the right Upright (14) and the Right Handrail (32). Do
not tighten the Handrail Bolt yet,
Attach the lower end of the Right Handrail (32) to the
Extension Leg (41) with a 3 1/2" Handrail Bolt (89), a 3/8"
Washer (99), and a Flange Nut (57).
Tighten all parts used in this step and in step 2
6. Attach the Storage Latch (12) to the left Upright (14) with
two 1/2" Screws (13). Be careful not to overtighten the
Screws.
Refer to the inset drawing. Remove the backing from the
Adhesive Clip (74). Press the Adhesive Clip onto the
base of the Uprights (14) in the indicated location. Press
the Allen Wrench (73) into the Adhesive Clip.
13
12
13
74 73
7 Make sure that all parts are tightened before you use the treadmill To protect the floor or carpet, place
a mat under the treadmill