Filter
Top Products
ASSEMBLY INSTRUCTIONS
8
NOTE: Lay your partially assembled 1215 Orbital Rower upside down to complete STEP 3 and 4.
STEP 3
Place the LEFT and RIGHT BASE FRAMES(2, 3) on the CENTER BEAM(1), connect them with the two
MOUNTING BRACKETS(4), and secure with HEX BOLTS(M8x1.25x16mm)(43) and LOCK WASHERS(M8)
(55).
STEP 4
Attach the REAR SUPPORT(16) to the SUPPORT BRACKET(15) with HEX BOLT(M10x1.5x95mm)(46)
and NYLOCK NUT(M10x1.5)(52). Lock the REAR SUPPORT(16) in position by inserting the PULLING
PIN(17) through the holes in the SUPPORT BRACKET(15) and REAR SUPPORT(16).