Filter
Top Products
MAINTENANCE OFYOLIR SCHWINN ®
ELLiPTiCALTRAiNER
==Moving your EllipticaITrainer
To move the elliptical trainer, carefully
but securely lift the rear end of the ellipti-
cal trainer and slowly steer the elliptical
trainer to the desired location (Fig A). Be
gentle while moving the unit as any sharp
impact directly or indirectly to the com-
puter can affect computer operation.
Fig. A
== Leveling your ENipticaITrainer
The elliptical trainer can be leveled to
compensate for uneven surfaces. To level
the 430, raise or lower the two leveling
bolts located on the underside of the rear
stabilizer by screwing them in or out as needed.
i Maintenance
Disconnect power supply before maintaining or servicing the elliptical trainer.
Use a damp cloth to wipe your elliptical trainer and computer free of sweat.
Inspect the elliptical trainer before each use. Replace all parts at the first
sign of wear or damage. Call your authorized Schwinn ® Fitness products
distributor if you have any questions on the proper use or maintenance of this
equipment or contact Nautilus Customer Service at 1-800-NAUTILUS (628-
8458).
The safety level provided by the design of this equipment can only be
maintained when the equipment is regularly examined for damage and
wear. Inoperable components should be replaced immediately or the
equipment be put out of use until it is repaired. Only Nautilus-trained or
Nautilus-authorized personnel should carry out extensions, readjustments,
modifications, or repairs.
Daily: Before each use inspect for loose, broken, damaged or worn parts.
Do not use if found in this condition; repair or replace.
WeeMy: Check for smooth rear roller operation. Wipe any dust, dirt, or
grime from the surfaces.
Monthly: Check all bolts and screws, and tighten as necessary.
iMPORTANT: To avoid damaging the finish on your elliptical trainer and
computer, never use a petroleum-based solvent when cleaning. Avoid getting
excessive moisture on the computer.
23