Filter
Top Products
7
2. Insert the tab on one of the Handrail Brackets (70) into
the indicated slot in the right Upright (69). Attach the
H
andrail Bracket with a 3/4” Tek Screw (65).
A
ttach the other Handrail Bracket (not shown) to the left
Upright (not shown) the same way.
While a second person holds the console assembly, re-
move the Console Bolts (78), the Handrail Star Washers
(77), and the Nuts (A) from both Uprights (69) and the
console assembly. Discard the Nuts.
A
65
70
78
77
69
Console
Assembly
Slot
3. While a second person holds the console assembly, insert
the upper end of one of the Handrails (55) into the console
assembly; make sure that the Handrail Bracket (70) is in-
side of the lower end of the Handrail. Tighten a 1 1/4” Tek
Screw (71) into the bottom of the Handrail. Repeat with
the other Handrail on the left side (not shown).
Next, insert two Console Bolts (78) with Handrail Star
Washers (77) into the right Upright (69) and the Handrail
(55). Finger tighten the Console Bolts;
do not fully tighten
the Console Bolts yet. Repeat with the Handrail on the
left side (not shown). After all four Console Bolts have
been started, tighten them.
55
78
77
69
70
Console
Assembly
2
3
71
4. With the help of a second person, carefully tip the
Uprights (69) down as shown. Make sure that the
Extension Legs (102) remain in the Uprights.
Attach each Extension Leg (102) with two 1” Tek Screws
(100) and one Base Pad (99) as shown; attach the lower
Tek Screw, without the Base Pad, first. Note: One re-
placement Base Pad may be included. Use the Base Pad
to replace any Base Pad that becomes worn.
99
69
102
100
4