Filter
Top Products
ASSEMBLY
A
ssembly requires two persons.
S
et the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver , wire cutters , and rubber mallet .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
To identify small parts during assembly, use the part identification drawings below. To avoid damaging
plastic parts, do not use power tools for assembly.
6
Handrail Star
Washer (77)–2
Foot Screw (74)–2
1 1/4” Tek Screw (71)–2
1
Wheel Bolt (94)–2
Nut (20)–2
1” Tek Screw (100)–4
Console Bolt (78)–2
3/4” Tek Screw (65)–2
1. With the help of a second person, carefully raise the
Uprights (69) to the position shown.
Next, insert one of the Extension Legs (102) into the base
of the Uprights (69) as shown. Make sure that the
Extension Leg is turned so the Base Pad (99) is un
-
derneath it. Note: It may be helpful to tip the Uprights for-
ward and use a rubber mallet to fully insert the Extension
Leg.
Insert the other Extension Leg (not shown) in the same
way.
69
99
102
1