Filter
Top Products
7
4. Apply a small amount of the included grease to the
sides of two Wave Washers (88) and two Thrust
Washers (66).
Slide a Weld Spacer (89) onto the Left Crank Arm
(83). Next, identify the Left Track Arm (12), which
is marked with an “L.” Orient the Left Track Arm as
shown, and slide it onto the Left Crank Arm. Then,
slide a Wave Washer (88) on the end of the Left
Crank Arm.
Slide an M8 Small Washer (18) and an Axle Cap
(41) onto an M8 x 19mm Button Screw (56). Next,
slide a Thrust Washer (66) onto the shoulder of
the Axle Cap. Then, tighten the Button Screw into
the end of the Left Crank Arm (83). Make sure
that the Thrust Washer remains on the shoul-
der of the Axle Cap, and that the Wave Washer
(88) remains on the end of the Left Crank Arm.
Repeat this step to attach the Right Track Arm
(11) to the right side of the elliptical exerciser.
11
83
89
88
41
56
12
18
66
5. Attach a Pedal (21) to the Left Pedal Leg (14) with
seven M10 x 13mm Button Screws (54), seven
M10 Split Washers (85), and seven M10 Washers
(67).
Attach the other Pedal (not shown) to the Right
Pedal Leg (not shown) in the same way.
5
21
67
67
85
85
54
54
14
6. Apply a thin film of grease to the barrel of an M10 x
65mm Bolt Set (94). Next, fit the bracket on the
Left Pedal Leg (14) onto the bracket on the Left
Track Arm (12). Attach the Left Pedal Leg to the
Left Track Arm with the Bolt Set.
Attach the Right Pedal Leg (not shown) to the
Right Track Arm (not shown) in the same way.
12
94
Grease
14
94
6
4
Grease