Filter
Top Products
9
7. With the help of a second person, hold the
handrail assembly near the Right Upright (77)
and the Left Upright (78). Connect the Wire
Harness (87) to the console wire. See the inset
drawing. The connectors should slide to-
gether easily and snap into place. If they do
not, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON.
Remove the wire tie from the Wire Harness (87).
Set the handrail assembly on the Uprights (77,
78). Be careful not to pinch the wires.
77
78
Console
Wire
Wire Tie
7
87
Console
Wire
Handrail
Assembly
87
6. Hold a Bolt Spacer (82) inside the lower end of
the Left Upright (78). Insert a 3/8" x 4" Bolt (4)
with a 3/8" Star Washer (8) into the Left Upright
and the Bolt Spacer. Repeat this step with a
s
econd Bolt Spacer (82), 3/8" x 4" Bolt (4),
and 3/8" Star Washer (8).
Hold the Left Upright Spacer (81) and the Left
U
pright (78) against the Base (84). Tighten the
3/8" x 4" Bolts (4) until the heads of the Bolts
touch the Left Upright; do not fully tighten the
Bolts yet.
Press a Base Cap (80) into the Base (84).
With the help of a second person, tip the tread-
mill so that the Base (84) is flat on the floor.
8
1
7
8
4
84
82
82
80
8
6